會議室音響的重要性是很大的,它是整個會議中是不可缺少一部分,在使用該音響設備的時候,應滿足很多的條件,按照具體的條件進行施工,這樣設備的效果才會更好,才不會出現噪音,那么大家應當注意會議室音響設備的使用條件。
The importance of conference room sound is very great. It is an indispensable part of the whole conference. When using this sound equipment, many conditions should be met, and the construction should be carried out according to the specific conditions, so that the effect of the equipment will be better and there will be no noise. Then everyone should pay attention to the use conditions of conference room sound equipment.
一般情況下,設備的操作條件會在設備的操作說明書中列出,如:
Generally, the operating conditions of the equipment will be listed in the operating instructions of the equipment, such as:
1.環境溫度為:-10-40;
1. Ambient temperature: -10-40;
2.相對濕度:50%-80%;
2. Relative humidity: 50% - 80%;
3.電源電壓:198v-242v;
3. Power supply voltage: 198v-242v;
4.電源頻率為:50Hz-60Hz-60Hz。
4. Power frequency: 50hz-60hz-60hz.
具體要求:
Specific requirements:
1.避免在低或高溫度環境下使用設備,避免陽光直射設備表面;
1. Avoid using the equipment in low or high temperature environment, and avoid direct sunlight on the surface of the equipment;
2.避免在潮濕的環境中使用設備,以避免設備部件過早失效或設備過早生銹;
2. Avoid using the equipment in a humid environment to avoid premature failure of equipment components or premature rusting of equipment;
3.使用前,需要確認本機電源電壓與本機一致。
3. Before use, it is necessary to confirm that the power supply voltage of the machine is consistent with that of the machine.
注意設備的使用環境
Pay attention to the operating environment of the equipment
1.避免在灰塵和振動環境中使用設備。
1. Avoid using the equipment in dust and vibration environment.
2.設備周圍應有足夠的間隙,以利于設備散熱。
2. There should be enough clearance around the equipment to facilitate the heat dissipation of the equipment.
3.對于功率放大器,應特別注意保持冷卻通道暢通。
3. For power amplifier, pay special attention to keep the cooling channel unblocked.
會議室音響設備使用中的注意點
Points for attention in the use of conference room audio equipment
1.在
山東音響系統中,要注意開機和關機的順序。開機時,先打開音源等前置設備,再打開功放;關機時,先關掉功放,再關掉關音源等前置設備。如果音響設備有音量旋鈕,盡量在開機關機前將音量旋鈕調到很小。這樣做的目的是減少揚聲器打開或關閉時對揚聲器的影響。
1. In Shandong sound system, pay attention to the sequence of startup and shutdown. When starting up, turn on the audio source and other front-end devices first, and then turn on the power amplifier; When shutting down, turn off the power amplifier first, and then turn off the front-end devices such as the sound source. If the audio equipment has a volume knob, try to turn the volume knob down before turning it on and off. The purpose of this is to reduce the impact on speakers when they are turned on or off.
2.嚴禁用電拔下或插上信號插頭,以免因撞擊而損壞設備或揚聲器。
2. It is strictly forbidden to unplug or plug in the signal plug with electricity to avoid damaging the equipment or speakers due to impact.
3.如果設備在運行過程中發出異常聲音,應立即關閉電源,停止使用。并請有經驗的合格維修人員進行維修。不要擅自打開設備,以免造成更大的設備損壞或觸電事故。
3. If the equipment makes abnormal sound during operation, turn off the power immediately and stop using it. And ask experienced and qualified maintenance personnel to repair. Do not open the equipment without authorization to avoid greater equipment damage or electric shock accidents.
在使用會議室音響設備的時候,一定要注意使用環境,千萬不要將其放在潮濕環境中,按照正確的方法進行使用,更多關于音響設備的內容您可以來我們網站
http://www.zkvd.cn咨詢看看。
When using the audio equipment in the conference room, you must pay attention to the use environment. Never put it in a humid environment and use it in the correct way. For more information about audio equipment, you can come to our website http://www.zkvd.cn Consult.